Changing the chain on your Husqvarna 450 chainsaw is a necessary maintenance task to keep your saw running smoothly. With some basic tools and safety precautions, you can remove the old worn chain and install a new one following a few easy steps.
#chainsaw #Husqvarna #maintenance #repair
What You’ll Need
- Safety gloves
- Screwdriver
- Replacement saw chain
- File and depth gauge tool
Before You Start
- Disconnect the spark plug wire. This prevents accidental starting while working.
- Wear protective gloves as the chain and other parts may be sharp.
Removing the Bar and Old Chain
- Loosen the side cover nuts and remove chain brake cover. This exposes the chain tensioner screw.
- Turn chain tensioner screw clockwise to loosen chain.
- Slide the bar toward engine to derail the chain. Lift it off the mounting surface.
- Clean the bar groove to remove debris before installing new chain.
#repair #maintenance #DIY
Installing the New Chainsaw Chain
- Lay out the new chain in a loop and engage lower part on the sprocket.
- Fit top of drive links into the bar groove. Ensure correct chain direction.
- Mount the bar back and slide it toward the chain brake.
- Turn tensioner screw counter-clockwise until chain is snug but still movable.
- Replace chain brake cover and finger tighten side nuts.
Adjusting Chain Tension
- Pull the chain around the bar by hand. It should have just a little slack.
- If too loose, turn tensioner screw more. If too tight, loosen it.
- Tighten side nuts with screwdriver when adjusted properly.
You did it! Your Husqvarna 450 has a new chain installed and ready to cut again. Be sure to refer to your owner’s manual if you have any additional questions. Regular chain maintenance and replacement is key to maximizing the saw’s performance.
#Husqvarna #450 #maintenance #chainsaw #DIY
Leave a Reply