Overview
Get your saw cutting clean again with this 10” guide bar and chain set. Both pieces are manufactured to original-equipment specifications, which means you get accurate chain tracking and dependable performance without paying OEM prices. Great for homeowners who rotate spare bars between sharpening sessions.
Key specifications
- Bar length: 10”
- Includes: guide bar and chain (matched set)
- Material: hardened alloy bar with chrome-plated chain
Compatibility
Fits WORX WG322 plus additional models with matching bar-mount specs. Cross-reference your chainsaw’s model and serial number with the compatibility table to confirm correct fitment before installing.
Installation notes
Remove the clutch cover and take off the spent bar and chain. Wipe down the bar pad and blow out the oiler port. Position the new bar, thread the chain onto the sprocket and around the bar groove making sure the cutters face forward on top. Use the tension screw to take up slack until the tie straps just lift off the bar rail, then secure the cover firmly.
Common questions
Q: Will this 10-inch guide bar and chain combo fit my WORX WG322 cordless chainsaw without any modification?
Yes, this combo is made to fit the WORX WG322 and matches the 10-inch bar length that model uses. As long as your saw is the WG322, the bar and chain should install in the original mounting position and work with the factory tensioning system.
Q: Does this combo come ready to install, and do I need to sharpen or adjust the chain first?
The bar and chain are intended as a direct replacement set, so you can install them right away after confirming the chain is routed correctly around the sprocket and bar. Before use, set the chain tension so it lifts slightly from the bar but the drive links stay engaged, and keep the chain properly oiled during operation.
Q: How do I know when this 10-inch bar and chain combo on my WORX WG322 needs maintenance or replacement?
If the chain starts cutting slowly, pulls to one side, or produces fine dust instead of chips, it likely needs sharpening or tension adjustment. Replace the combo if the bar groove is worn, the nose area shows excessive wear, or the chain has damaged or stretched links that no longer hold proper tension.
