Overview
Get your saw cutting clean again with this 14” guide bar and chain set. Both pieces are manufactured to original-equipment specifications, which means you get accurate chain tracking and dependable performance without paying OEM prices. Great for homeowners who rotate spare bars between sharpening sessions.
Key specifications
- Bar length: 14”
- Chain pitch: 3/8”
- Drive links: 52DL
- Includes: guide bar and chain (matched set)
- Material: hardened alloy bar with chrome-plated chain
Compatibility
Engineered to fit EGO CS1400 saws and other models sharing the same bar-mount pattern. Always double-check your saw’s model number against the full compatibility list before ordering, since mount studs and oiler holes can vary between production years.
Installation notes
Remove the side cover, slide the old bar off the studs, and clean any sawdust from the bar-mount area and oil port. Seat the new bar on the studs, loop the chain around the sprocket and bar nose, then hand-tighten the cover nuts. Adjust chain tension until the chain pulls away from the bar bottom about 1/8 inch and snaps back, then torque the nuts securely.
Common questions
Q: Will this 14-inch bar and chain combo fit my EGO CS1400, or is it only for gas saws with a 3/8 pitch setup?
Yes, this combo is made to be compatible with the EGO CS1400 and matches the 14-inch bar length and 3/8 pitch spec for that saw. As long as your saw is the CS1400 model, this is the correct style of bar and chain combo to replace the original setup.
Q: Do I need to do anything special when installing this 14-inch guide bar and chain on my EGO CS1400?
When installing it, make sure the chain is routed in the correct cutting direction and seated properly in the bar groove and around the drive sprocket. After tensioning, the chain should pull slightly away from the bar but still snap back into place, and it’s a good idea to recheck tension after the first few cuts since a new chain can stretch a bit.
Q: What kind of maintenance will help this 14-inch 3/8 pitch chain last longer on my EGO CS1400?
Keep the chain sharp, maintain proper tension, and make sure the bar oil reservoir stays filled so the bar and chain are continuously lubricated. It also helps to clean the bar groove and oiling holes regularly and flip the guide bar occasionally to promote more even wear.
