Overview
Designed as a drop-in aftermarket replacement, this 14” bar and chain combo takes the guesswork out of ordering parts separately. The bar rail and chain pitch are matched at the factory, so everything lines up the first time you mount it. A practical upgrade for homeowners maintaining their own firewood saws.
Key specifications
- Bar length: 14”
- Includes: guide bar and chain (matched set)
- Material: hardened alloy bar with chrome-plated chain
Compatibility
Designed for WORX WG305 and other saws with identical bar-mount dimensions. Before purchasing, verify your specific model number in the compatibility listing, as some saws within a product line use different bar studs or tensioner positions.
Installation notes
Remove the side cover, slide the old bar off the studs, and clean any sawdust from the bar-mount area and oil port. Seat the new bar on the studs, loop the chain around the sprocket and bar nose, then hand-tighten the cover nuts. Adjust chain tension until the chain pulls away from the bar bottom about 1/8 inch and snaps back, then torque the nuts securely.
Common questions
Q: Will this 14-inch guide bar and chain combo fit my WORX WG305 exactly, or do I need to modify anything?
Yes, this combo is made to fit the WORX WG305 with a 14-inch setup, so it should install without modification when you’re replacing the original bar and chain size. Just make sure your saw is the WG305 model and compare the mounting slot and chain tensioner position with your current bar before installation.
Q: Does this combo come ready to install on a WORX WG305, and what should I check when putting it on?
It is designed as a direct replacement bar and chain combo for the WORX WG305, but you should still confirm the chain is routed correctly around the sprocket and bar with the cutting teeth facing forward on the top side of the bar. After installation, tension the chain so it snaps back lightly when pulled away from the bar, then add bar oil and recheck tension after a few minutes of use.
Q: How often should I maintain this 14-inch bar and chain combo on my WG305 to keep it cutting well?
Check chain tension and bar oil level every time you use the saw, especially with a new chain since it can stretch slightly during the first few cuts. It’s also a good idea to clean the bar groove, inspect the drive links, and sharpen the chain regularly so the WORX WG305 cuts smoothly without putting extra strain on the motor.
