Overview
Pair a fresh 25” bar with a factory-sharp chain in one package. This aftermarket combo replaces the original equipment on your saw and arrives ready to mount, so you can get back to cutting without delay. It is a practical choice when your current bar is worn or your chain has seen too many sharpenings.
Key specifications
- Bar length: 25”
- Chain pitch: 3/8”
- Drive links: 84DL
- Includes: guide bar and chain (matched set)
- Material: hardened alloy bar with chrome-plated chain
Compatibility
This combo is built to work with Stihl MS 362 and equivalent models that share the same bar-mount geometry. Confirm your saw’s model and year against the compatibility chart to ensure a proper fit, particularly if your saw has been updated with a different oiler setup.
Installation notes
Loosen the bar-mount nuts and slide the old assembly off. Before fitting the new bar, clear packed sawdust from the oil passage and around the drive sprocket. Place the new bar onto the studs, route the chain around the bar groove and sprocket, then adjust tension to the point where you can pull the chain around by hand with light resistance. Snug the nuts in a cross pattern.
Common questions
Q: Will this 25 inch 3/8 bar and chain combo fit my Stihl MS 362 without any modifications?
Yes, this combo is made for the Stihl MS 362 with a 25 inch setup and 3/8 pitch, so it should fit correctly when your saw is using the matching bar mount and chain specs. Before installing, it’s still a good idea to confirm your current drive link count and gauge match your existing setup so chain tension and oiling work properly.
Q: Can I switch my MS 362 from a 24 inch bar to this 25 inch guide bar and chain combo, or do I need to change anything else?
In most cases, moving from a 24 inch setup to a 25 inch bar on an MS 362 is fine as long as the bar mount, 3/8 pitch, and chain gauge are correct for your saw. You’ll want to make sure the chain supplied with the bar matches that exact bar length, and after installation check chain tension carefully since a longer bar can slightly change how the saw balances and cuts.
Q: What’s the best way to install and maintain this 25 inch bar and chain combo on my Stihl MS 362?
When installing, mount the bar fully on the studs, seat the chain correctly around the sprocket and along the bar groove, then tension it so the chain lifts slightly from the bar but the drive links stay engaged. For maintenance, keep the chain sharpened, clean the bar groove and oil holes regularly, and recheck tension after the first few cuts because a new chain will usually stretch a bit during break-in.
