Overview
Designed as a drop-in aftermarket replacement, this 24” bar and chain combo takes the guesswork out of ordering parts separately. The bar rail and chain pitch are matched at the factory, so everything lines up the first time you mount it. A practical upgrade for homeowners maintaining their own firewood saws.
Key specifications
- Bar length: 24”
- Chain pitch: 3/8”
- Includes: guide bar and chain (matched set)
- Material: hardened alloy bar with chrome-plated chain
Compatibility
Designed for HUSQVARNA 372XP and other saws with identical bar-mount dimensions. Before purchasing, verify your specific model number in the compatibility listing, as some saws within a product line use different bar studs or tensioner positions.
Installation notes
Start by loosening the side-cover nuts and removing the worn bar and chain. Clean the bar pad and oil hole thoroughly. Mount the new bar, drape the chain over the nose sprocket and drive sprocket, and reinstall the cover. Set the tensioner so the chain has slight sag on the underside but stays in the rail, then fully tighten the cover.
Common questions
Q: Will this 24-inch bar and chain combo fit my Husqvarna 372XP without changing the sprocket?
On a Husqvarna 372XP, this combo is a match as long as your saw is set up for a 3/8 pitch chain, which is the common setup for that model with a 24-inch bar. It’s still smart to confirm your current drive sprocket and bar mount before installation, especially if the saw was previously converted to a different pitch.
Q: Does this 24-inch guide bar and chain combo come ready to install on a 372XP, or do I need to adjust chain tension first?
You’ll still need to install the bar and chain, route the chain correctly over the clutch drum, and set the chain tension before use. After tightening the bar nuts, make sure the chain snaps back against the bar but still pulls around by hand with a gloved hand, then recheck tension after the first few cuts.
Q: What kind of maintenance should I do to keep this 24-inch 3/8 chain and bar cutting well on my Husqvarna 372XP?
Keep the chain sharp, maintain proper chain tension, and make sure the bar oil hole and groove stay clear so the 24-inch bar gets full lubrication. It also helps to flip the guide bar periodically for even wear and inspect the drive links and bar rails if the saw starts cutting crooked.
