Overview
Designed as a drop-in aftermarket replacement, this 32” bar and chain combo takes the guesswork out of ordering parts separately. The bar rail and chain pitch are matched at the factory, so everything lines up the first time you mount it. A practical upgrade for homeowners maintaining their own firewood saws.
Key specifications
- Bar length: 32”
- Chain pitch: 3/8”
- Drive links: 105DL
- Includes: guide bar and chain (matched set)
- Material: hardened alloy bar with chrome-plated chain
Compatibility
Engineered to fit stihl MS440 saws and other models sharing the same bar-mount pattern. Always double-check your saw’s model number against the full compatibility list before ordering, since mount studs and oiler holes can vary between production years.
Installation notes
Remove the side cover, slide the old bar off the studs, and clean any sawdust from the bar-mount area and oil port. Seat the new bar on the studs, loop the chain around the sprocket and bar nose, then hand-tighten the cover nuts. Adjust chain tension until the chain pulls away from the bar bottom about 1/8 inch and snaps back, then torque the nuts securely.
Common questions
Q: Will this 32 inch bar and chain combo fit my Stihl MS440 without any modifications?
Yes, this combo is intended for the Stihl MS440 and uses a 32-inch bar with a 3/8 pitch chain, which is a common setup for that saw. You should still confirm your saw’s bar mount and chain gauge match your current setup before installation, especially if your MS440 was previously running a different bar length.
Q: Can I install this 32 inch guide bar and chain on my MS440 myself, and do I need to adjust anything after mounting it?
Installation is straightforward if you’ve changed a bar and chain before: remove the clutch cover, swap the old bar and chain, set the chain around the sprocket, and tension it properly before tightening everything down. After install, check that the chain moves freely by hand, verify the oiler is feeding the bar, and recheck chain tension after the first few cuts since a new chain will seat in quickly.
Q: Is a 3/8 pitch chain the correct choice for a 32 inch bar on a Stihl MS440, and what maintenance matters most with this setup?
A 3/8 pitch chain is the standard heavy-duty choice for a 32-inch setup on an MS440, giving good cutting performance for larger wood. For best results, keep the chain sharp, maintain correct tension, clean the bar groove and oil holes regularly, and flip the bar periodically to help it wear evenly.
